Xigmatek Odin II 750W 80 Plus White Black Power Supply

✅ Authorized Xigmatek Partner in Egypt | Official 3-Year Warranty | Expert PC Building Consultation Available

⚡ Engineering Highlights at a Glance:

• 750W Single +12V Rail: Delivers up to 54.5A on the +12V rail for stable power to modern CPUs and GPUs .
• 80 PLUS White Certification: Achieves at least 80% efficiency at 50% system load, reducing waste heat compared to uncertified units.
• 120mm Sleeve Bearing Fan: Provides effective cooling with quiet operation under load .
• Active PFC: Improves voltage stability and reduces electrical interference for more reliable power delivery.
• Full Protection Suite: Includes OCP, OPP, UVP, and OVP safeguards against overcurrent, overpower, undervoltage, and overvoltage .
• Compact 140mm Chassis: Fits more easily into smaller cases than longer 160mm or 180mm PSUs .
• Dual CPU & PCIe Connectors: Includes 2 x 4+4-pin CPU connectors and 2 x 6+2-pin PCIe connectors for broad component compatibility .

Efficiency and Power Draw

The Odin II is 80 PLUS White certified, achieving at least 80% efficiency at 50% load. This is lower than Bronze, Gold, or Platinum units, so it produces more waste heat and draws slightly more from the wall for the same output. For a budget build where initial cost matters most, this is a reasonable trade-off. For high-end systems running near 750W for long sessions, a more efficient PSU would be a better fit.

Connectors and Compatibility

The PSU includes two 4+4-pin CPU connectors, two 6+2-pin PCIe connectors, six SATA connectors, and two Molex connectors. Check your GPU’s power requirements before purchase; if your card needs three 8-pin PCIe cables or a 12V-2×6 connector, this PSU does not provide them. The 220–240V AC input matches Egyptian mains voltage, so it operates normally in local builds.

Cable Management and Airflow

The Odin II is non-modular, so all cables are permanently attached. Plan cable routing before installing the PSU, and tuck unused cables behind the motherboard tray. The 120mm fan intake should remain unobstructed; in a bottom-mounted position, ensure the case has a dust filter and at least 2cm of clearance below the PSU. Keep the PSU away from heat sources to help the fan maintain low noise.

Check your GPU’s power connectors before ordering. The Odin II includes two 6+2-pin PCIe cables, which covers most mid-range graphics cards. If your GPU needs a 12V-2×6 connector or three 8-pin cables, this PSU is not the right fit.

Because the cables are non-modular, route the 24-pin and CPU cables first, then the PCIe and SATA cables, and tuck unused cables behind the motherboard tray. The non-modular design keeps the build simple but requires planning to avoid clutter.

Keep the PSU intake unobstructed. In a bottom-mounted position, ensure the case has a dust filter and at least 2cm of clearance below the PSU. The 120mm fan runs quietly at low loads, but it will become audible under heavy load, which is normal for a budget-focused unit.

The Odin II is 80 PLUS White, so it is less efficient than Bronze or Gold units. For a budget build where initial cost is the priority, it is a practical choice. For a high-end system running near 750W for long sessions, a more efficient PSU would reduce heat and power costs. The 3-year Alfrensia warranty covers manufacturing defects.