✅ Authorized UGREEN Partner in Egypt | Official Warranty Coverage | Expert PC Building Consultation Available

⚡ Engineering Highlights at a Glance:

• Cat6 UTP Standard: 250MHz bandwidth for reduced crosstalk and system noise compared to Cat5e.
• 1Gbps Data Transfer: Supports Gigabit Ethernet for LAN, router, switch, and patch panel connections.
• Flat Cable Design: Routes under carpets, along baseboards, and through door gaps without creating a bump.
• RJ45 Connectors: Standard Ethernet plugs with molded strain relief to protect against damage from repeated bending.
• 30-Meter Length: Extended run for connecting rooms, offices, or distant network devices.
• OFC Copper Conductors: Oxygen-free copper for stable signal transmission over the full length.
• Wide Compatibility: Works with PCs, routers, switches, modems, smart TVs, game consoles, and patch panels.

30-Meter Length and Signal Integrity

The maximum recommended length for Cat6 1Gbps Ethernet is 100 meters, so 30 meters is well within spec. However, flat cables are more sensitive to sharp bends than round cables. Route the cable with gradual curves and avoid tight kinks or stapling through the cable body. If you must bend it around a corner, use a cable clip or trunking to maintain a safe radius.

UTP vs. STP — When Unshielded Is Enough

This is a UTP (unshielded twisted pair) cable. For home and office environments with normal electromagnetic interference, UTP Cat6 provides reliable 1Gbps performance. If you are routing the cable alongside power lines, near industrial equipment, or in an environment with heavy electromagnetic noise, an STP (shielded) cable would provide better protection. For most residential and small office setups, UTP is sufficient.

📐 Flat Cable Routing Tips

The flat profile is best for under-carpet and along-baseboard runs. Avoid running it under heavy furniture legs where constant pressure could compress the cable and affect performance. The connectors add a small bump where they connect; plan your routing so the plugs sit in accessible locations. For permanent installations, use cable clips or adhesive trunking every 30–50cm to keep the cable in place.

Plan the cable route before installation. Because the cable is flat, it can be tucked under carpet edges and along skirting boards without creating a trip hazard or visible bulk. Avoid routing the cable parallel to mains power lines for extended distances; if the cable must cross power, cross at 90 degrees to minimize electromagnetic interference. Test the cable end-to-end before running it permanently by connecting the router to the target device and confirming the link speed in the network adapter settings. If you are installing in a rented apartment, use adhesive clips rather than staples to avoid damaging walls. The gold-plated connectors resist corrosion, but keep the RJ45 plugs clean and avoid pulling the cable by the connector when removing it from a port. For 2.5Gbps or 10Gbps networking, Cat6 can support 2.5Gbps up to 100 meters and 10Gbps up to 55 meters, but confirm your router and network adapter support those speeds before assuming compatibility.